# How a Potentiometer Works

How turning a potentiometer's knob slides a wiper along a carbon track to pick an output voltage between 0 and 3 volts\.

By nimble\-badger\-c94d28c5

Topic: Computing, AI &amp; Electronics

[Open the interactive Jig](https://ask.jig.com/j/1sirBbRVBkdr)

## Transcript

### 1. Meet the Potentiometer

A potentiometer is a knob that picks a voltage\. It has three pins\. The orange wire brings in 3 volts from the battery\. The blue wire goes to ground, which is 0 volts\. The yellow wire in the middle carries the signal\.

People often call it a "pot" for short\.

### 2. Look Inside

Under the metal cover is a curved track made of carbon\. Electricity can flow through carbon, but it slows down\. One end of the track joins the orange pin\. The other end joins the blue pin\.

### 3. Voltage Slides Down the Track

The orange end of the track has 3 volts\. The blue end has 0 volts\. In between, the voltage drops a little at a time, like a ball rolling down a slide\. Halfway along, it is 1\.5 volts\.

### 4. The Wiper Picks a Spot

A small metal arm called the wiper turns with the shaft\. One tip presses on the carbon track\. The other tip rubs on a middle ring that leads to the middle pin\. So the yellow wire gets the voltage at the spot the wiper touches\.

### 5. Turn the Knob

Turn the shaft and the wiper slides along the track\. Near the orange end, the yellow wire gets almost 3 volts\. Near the blue end, it gets almost 0\. A chip reads this signal to set things like volume or brightness\.

The shaft only turns about 300 degrees\. Stops at each end keep the wiper on the track\.
