# Item Installation Column Portal

How a modular aluminium supply portal carries power, data and compressed air over obstacles to a compact workstation on the factory floor\.

By M\. Wendelin

Topic: Engineering

[Open the interactive Jig](https://ask.jig.com/j/AQJzxWUCRONL)

## Transcript

### 1. A supply portal on the factory floor

Machines and workbenches need power, data and often compressed air\. This item installation column carries them overhead in a portal of aluminium profiles\. Let us see why planning it from modular parts pays off\.

Drag anywhere in the hall to look around the portal\.

### 2. Something is in the way

Supply lines often have to cross stairs, machines or pipe runs\. A cable lying on the floor is a trip hazard and wears out quickly\. Lifting the lines overhead keeps the walkway clear\.

### 3. Three profiles make a portal

Two upright profiles stand on either side of the obstacle, and a third profile bridges across the top\. In this model the opening is about 2 metres wide and 2 metres high\. No wall or ceiling is needed to hold it up\.

A profile is a long aluminium bar shaped by pushing hot metal through a die, a bit like squeezing toothpaste\.

### 4. Cables travel inside

The profiles are hollow, so the lines run inside them, protected from knocks and dirt\. Press the button to send the supply from the cabinet up the column, across the bridge and down to the workstation\.

Orange line: power\. Blue line: data\. White line: compressed air\.

### 5. Outlets right where you work

At the end of the route, the supply unit offers K76 installation outlets and a control panel\. Extra sockets can be clipped straight into the cable ducts, so plugs sit exactly where the work happens\.

### 6. A compact workstation

An eight\-sided worktop wraps around the column just under 1 metre above the floor, a comfortable standing height\. Parts and tools go on top while power comes from the column itself\. One column becomes a small workstation\.

### 7. Built around what is already there

The same portal can stand over stairs, a conveyor or a pipe run\. The building stays as it is and the supply adapts to it\. Try each obstacle and watch the portal stay in place\.

### 8. Plan it first in the Engineeringtool

In the item Engineeringtool the whole portal is configured on screen first: profiles, outlets, sockets and worktop\. Because it is built from standard modules, it can be changed, extended or moved later\.

Switch the planning view off to compare the plan with the built portal\.
