ExploreMy JigsMission
MakeMake a Jig

© JigSpace Inc. 2026

jig.comContact@JigSpace on X

Woodworking Furniture Builder

publicRemix · Free
MBy Matthieu LÉAUTHAUD

A workshop game: measure, saw, chisel, fit, clamp, top and sand a real wooden stool

Transcript

9 steps · 2 min read
  1. 1

    Step 1: Your Workshop Order: A Stool

    Everything you need is on the bench: two pine boards, four rails, a seat board and the tools. Your job is to turn them into a sturdy little stool, one task at a time.

    Drag to look around the bench.

  2. 2

    Step 2: Measure and Mark

    Each board makes two legs, 428 mm long. A try square, an L-shaped ruler, keeps the pencil line exactly across the board. Woodworkers say: measure twice, cut once.

  3. 3

    Step 3: Saw the Legs

    A backsaw has a stiff spine so it cuts straight. Saw just beside the line, on the waste side, so every leg keeps its full length.

    A shop "2×4" is really 1.5 × 3.5 inches: boards shrink as they dry and get planed smooth.

  4. 4

Step 4: Chop a Mortise

A mortise is a slot cut into the leg. Tap the chisel with a wooden mallet and chip the slot out, a little at a time. Each leg gets one slot for every rail it holds.

  • 5

    Step 5: Dry Fit the Frame

    Each rail ends in a tenon, a tongue that fits its mortise snugly. Push everything together without glue first, to check that it all fits.

    Mortise and tenon is among the strongest joints for chairs and tables.

  • 6

    Step 6: Glue and Clamp

    Spread glue in every joint, then squeeze the frame with clamps until the glue sets. Measure corner to corner both ways: equal diagonals mean the frame is square.

  • 7

    Step 7: Fit the Seat

    Short wooden pins called dowels go into holes in the top of each leg. The seat board drops onto them, so it cannot slide off.

  • 8

    Step 8: Sand It Smooth

    Rub sandpaper along the grain, the lines that run through the wood. Start with coarse paper, then finish with fine paper for a silky seat.

    A sanding block keeps the paper flat, so the edges stay crisp.

  • 9

    Step 9: Order Complete!

    Your stool stands on its own four legs. Its seat is 45 cm high, close to a dining chair, and good joints hold it together without a single screw.

    Go back to any step and press its button to do that job again.