# RXN\-E Pack Out Steps

How to pack an RXN\-E insulated shipper for 2 to 8 °C transport, layering bubble wrap, refrigerated and frozen gel packs around the medicine\.

By Cedric D'Souza

Topic: Home &amp; DIY

[Open the interactive Jig](https://ask.jig.com/j/DUU958OVlr8o)

## Transcript

### 1. RXN\-E Pack Out

This insulated shipper keeps medicine between 2 and 8 °C on its journey\. Inside the carton is a kraft\-paper liner\. You will add bubble wrap, the product and four gel packs \(cold packs\)\. Tap any part to see its name\.

Keep frozen packs at about 22 °C for roughly 30 minutes first, so they warm to −5 to 0 °C\.

### 2. 1 · Bubble Wrap on the Base

Lay two 12″ × 12″ sheets of 5/16″ bubble wrap flat on the base of the shipper\. The trapped air cushions the product from the cold base\.

### 3. 2 · Place the Product

Set your temperature sensitive product in the centre, on top of the bubble wrap\. If you use a temperature indicator, lay it directly on top of the product\. The indicator is optional\.

The most product this shipper is recommended to carry is 2\.8 kg \(6\.2 lb\)\.

### 4. 3 · Refrigerated Gel Packs

Place two refrigerated 624AV\-2\-S gel packs on top of the product\. These packs are kept at about \+5 °C, so they cool the product without freezing it\.

### 5. 3 · Bubble Wrap Over the Packs

Lay two more 12″ × 12″ sheets of bubble wrap over the gel packs\. Tuck them down around the product so it sits snugly\.

### 6. 4 · Frozen Gel Packs

Place two frozen 624AV\-2\-S gel packs on top of the bubble wrap\. The wrap keeps their deep cold from touching the product directly\. Fill any extra space with more bubble wrap\.

The extra filler is not shown here\.

### 7. 5 · Fold the Liner Flap

Fold the top flap of the insulation down over the payload\. Push it flat across the side walls so the cold stays sealed inside\.

### 8. 6 · Close the Flaps

Fold the outer carton’s two short end flaps in first\. Then close the two long flaps over them\.

### 9. 6 · Tape It Closed

Run packing tape along the centre seam to close the outer corrugated carton\. The shipper is packed and ready to go\.

Fully packed, it measures 416 × 365 × 349 mm and weighs about 4 kg plus the product\.
