# Bathroom Cabinet Assembly

Build a tall bathroom cabinet step by step, from the feet to the wall fixing

By jos

Topic: Home & DIY

[Open the interactive Jig](https://ask.jig.com/j/PhDjAvgTdiht)

## Guide

### 1. Bathroom Cabinet Assembly

Here is everything for a tall bathroom cabinet: two sides, a top and a base, three shelves, a thin back panel, two doors, a drawer, four feet and a small wall angle\. Finished, it stands 1\.9 metres tall but only 38 centimetres wide\. Tap any part to see its name\.

Lay the boards on the flattened box so the shiny fronts stay scratch\-free\. It is a job for two people\.

### 2. 1 · Fit the Four Feet

Turn the base board upside down\. Set a round foot over each corner hole, 4 cm in from both edges, and screw it on\.

### 3. 2 · Set the Base Down

Turn the base over so it stands on its feet, close to the wall where the cabinet will live\. The groove on its top face goes at the back\.

### 4. 3 · Stand the Left Side Up

Lower the left side onto the base so its wooden dowels, little ribbed pegs, drop into the holes\. The groove on its inner face goes at the back\.

Ask your helper to hold the tall side steady\.

### 5. 4 · Add the Three Shelves

Push the fixed shelves onto the dowels in the left side\. The round cam locks on top of each shelf will grip the side like tiny clamps once they are turned\.

### 6. 5 · Close With the Right Side

Press the right side onto the other ends of the shelves and onto the base\. Turn each cam lock clockwise with a cross\-head screwdriver until it is firm\.

### 7. 6 · Slide In the Back Panel

Feed the thin back panel down the grooves at the back of both sides until it sits in the base groove\. It keeps the whole cabinet square\.

### 8. 7 · Put the Top On

Lower the top onto the sides so the back panel slips into its groove too\. Lock its cam fittings the same way\.

### 9. 8 · Fix It to the Wall

Screw the wall angle to the top, then into the wall with the plug and screw supplied\. A tall, narrow cabinet can tip over, so this step matters most\.

Check what your wall is made of and use a plug that suits it\.

### 10. 9 · Hang the Doors

Clip each door’s hinges onto the plates inside the cabinet, then tighten the hinge screws\. Small turns of the hinge screws line the doors up evenly\.

The doors can hang on the left or the right side\. Pick one before you start\.

### 11. 10 · Slide the Drawer In

Rest the drawer on its metal runners and push it in\. The runners roll on tiny steel balls, so it glides smoothly\.

### 12. Done

Press the round caps onto the cam locks and peel the protective film off the fronts\. Wait a day before wiping the shiny fronts, then fill it with towels\.