# Golf Ball Dimple Aerodynamics

How dimples shrink the wake, lower drag and sustain lift, and how clubs and balls differ

By Ham Sandwich

Topic: Sport

[Open the interactive Jig](https://ask.jig.com/j/TUtRObUiVzq1)

## Transcript

### 1. A ball built to fly

A golf ball is at least 42\.67 mm across and weighs no more than 45\.93 g\. Its cover carries roughly 300 to 400 shallow dimples, each only about a quarter of a millimetre deep\. Drag the ball to turn it, or drag the sky to walk around it\.

Across 97 ball models, the median dimple count was 338\. The ball here is shown about 12 times life size\.

### 2. A smooth ball drags a big wake

Picture this ball with no dimples at all\. Air flows smoothly around the front, but it cannot follow the curved back\. It peels away early, near the ball's widest point, and leaves a wide, swirling wake\. That low\-pressure wake pulls the ball backwards\. This pull is called drag\.

The smoke shows the air as the ball sees it: the ball flies to the right, so air streams past from right to left\. On a smooth sphere it separates about 80° from the front\.

### 3. Dimples trip the air

Dimples stir the thin layer of air touching the ball into a turbulent boundary layer\. Turbulent air carries more energy, so it hugs the surface further around the back before letting go\. The wake shrinks, and so does the drag\. Switch between the two surfaces and compare the wakes\.

The same trick is used on some race\-car parts and swimsuits\. Roughness can lower drag, but only for bluff, round shapes like a ball\.

### 4. The drag crisis

The trick only works when the ball is fast enough\. Below about 20 m/s, both balls feel similar drag\. Above it, the dimpled ball's drag coefficient suddenly falls to about half\. A smooth ball \(orange curve\) would need about six times the speed\. Slide the speed and watch the white dimpled curve and the wake\.

Engineers track this with the Reynolds number: speed × diameter ÷ air viscosity\. A tour driver launches near Re 220,000, well past the dimpled drop\.

### 5. Backspin makes lift

A well\-struck ball spins backwards, thousands of times a minute\. The spinning surface helps the air over the top stay attached longer and throws the wake downward\. Pushing air down pushes the ball up\. This Magnus lift keeps a golf shot in the air far longer\. Dimples make the effect much stronger\.

Tour drives spin about 2,500 rpm, and wedge shots more than 9,000 rpm\. Too much spin adds drag and makes the ball balloon\.

### 6. Smooth versus dimpled

Two balls are launched with the same tour driver strike: 76 m/s \(171 mph\), 10\.9° up, 2,545 rpm of backspin\. Only the surface differs\. In this model, the dimpled ball carries about 274 yards\. The smooth ball dives after about 129 yards, less than half as far\.

Early golfers found that scuffed, hand\-hammered balls flew further than new smooth ones\. Ball makers soon began to add patterns on purpose\.

### 7. Driver, iron or wedge

Each club changes the launch\. A driver sends the ball fast and low with little spin\. A 7\-iron launches higher with nearly three times the spin\. A wedge is slower, steeper and spins more than 9,000 rpm\. The dimples help every shot, but spin and speed decide its shape\.

PGA Tour averages \(TrackMan\): driver 171 mph, 10\.9°, 2,545 rpm; 7\-iron 123 mph, 16\.3°, 7,124 rpm; wedge 104 mph, 24\.2°, 9,316 rpm\.

### 8. Different balls, different dimples

Ball makers tune the size, depth and layout of their dimples\. A Titleist Pro V1 has 388 dimples, while the Pro V1x has 348 and flies higher\. TaylorMade's TP5 uses 322\. The patterns change lift, drag and launch height a little\. Most of the difference between balls comes from their layers and spin, not the count alone\.

The rules set the same minimum size, maximum weight, speed limit and symmetry tests for every brand\. In this model the three patterns change a tour drive's carry by only about 4 yards, an illustrative estimate\.
