How a Transrapid-style maglev train levitates, stays centred and is driven by a motor in the track, on a 1:10 cut-away section
This is a 1:10 model of a Transrapid maglev train, the type that runs in Shanghai. It has no wheels, no axles and no overhead wire. Magnets hold it about a centimetre clear of its concrete guideway.
Drag to turn the model. A real section is 3.7 m wide and about 25 m long.
The cut end shows the trick. The train’s skirts hang down beside the beam and tuck their arms underneath it, so the train wraps around its track like a hand around a rail.
Because it holds on from below, this train cannot fall off the beam.
Electromagnets on the arms sit under steel plates fixed to the beam’s overhang. Switched on, they pull up towards the steel and lift the whole train off its landing skids.
Pure attraction is unstable: the closer the magnet gets, the harder it pulls. Sensors measure the gap and a controller trims the current to hold it near 10 mm. Freeze the current and see what happens without it.
The control electronics check the gap 100,000 times a second.
A second set of magnets faces steel rails on the sides of the beam. When a gust pushes the train sideways, the controller raises the current on the side the train is pushed away from, and those magnets draw it back to the centre.
The steel plates hold three-phase coils. Switched in sequence, they make a magnetic wave that runs along the beam, and the train’s magnets ride that wave. Speed it up and the train follows.
The train carries no engine. In Shanghai it runs at up to 431 km/h.
This train is pulled up from below and floats even at a standstill. Japan’s SCMaglev works the other way: superconducting magnets are pushed up by currents they induce in the track, so it only lifts off at speed.
SCMaglev rides about 10 cm high and holds the rail speed record of 603 km/h.