# IKEA \- KOMPLEMENT Clothes Rail

Fit an IKEA KOMPLEMENT clothes rail in a PAX frame step by step, following manual AA\-938836

Model credits \(Sketchfab\):
“Phillips Head Screw Driver” by brandonh111121, via Sketchfab \(https://sketchfab\.com/3d\-models/78c516b16ecc4b12bb2e6d90d031596e\)\. CC\-BY\-4\.0: https://creativecommons\.org/licenses/by/4\.0/ Prepared for Jig; static geometry/material conversion\.

By Numa

Topic: Home & DIY

[Open the interactive Jig](https://ask.jig.com/j/dI9SttH1vshU)

## Guide

### 1. KOMPLEMENT Clothes Rail

This is the white KOMPLEMENT clothes rail for a PAX frame 75 cm wide and 58 cm deep\. The rug holds the two rail holders, four screws, the rail tube and a cross\-head screwdriver\. Tap a part to see its name\.

Use a hand screwdriver, not a power screwdriver\.

### 2. 1 · Set the First Holder on the Left Side

Hold one holder against the inside of the left side panel with its two screw holes lined up with two holes of the panel, one above the other, and its cup open towards you\.

### 3. 1 · Screw In the First Screw

Put a screw through the upper hole of the holder and turn it clockwise with the cross\-head screwdriver until it is tight\.

### 4. 1 · Screw In the Second Screw

Fix the lower hole the same way with the second screw\.

### 5. 1 · Set the Second Holder on the Right Side

Put the other holder on the right side panel at the same height, with its cup open towards you, like the first\.

### 6. 1 · Screw In the Other Two Screws

Screw the last two screws into the right holder, turning clockwise until they are tight\.

### 7. 2 · Click the Rail Into the Holders

The rail has a small hole near each end\. Hold the rail in front of the two holders with the holes facing the back\. Push it straight back until both ends click into the cups\.

The rail is only held by the clip at each end, so hang clothes evenly along it\.