# Pallet Truck Ram and Plunger Seal Replacement

Replace the ram and plunger seals in a hand pallet truck pump, following the JET PTW service manual steps

By Numa

Topic: Home &amp; DIY

[Open the interactive Jig](https://ask.jig.com/j/fghXLirfHRjJ)

## Transcript

### 1. 1 · Raise the Forks

Raise the pallet truck to maximum height by pumping handle\.

Repairs and seal ring replacements should be performed only by qualified personnel\.

### 2. 2 · Unscrew Set Screw \#102

Unscrew the set screw \(\#102\) to release the ram shaft from the top of the frame\.

Do not place hands or feet under the pallet truck at any time\.

### 3. 3 · Free the Pump Assembly

Turn the pallet truck on its side\. Remove the wheels and wheel shaft\. Remove the C\-clip \(\#78\)\. This will free the pump and handle assembly from the main truck body\.

### 4. 4 · Drain the Oil

Turn the pallet truck upright\. Remove drain plug \(see Figure 7\) and empty the oil into a suitable container\. Pump handle until all oil has drained\.

Figure 7 is in the printed manual; the drain plug is highlighted here\. The pump assembly is already out, so it is the pump that stands upright in the tray\.

### 5. 5 · Pull Out the Pistons

Pull out ram piston \(\#59\)\. If plunger piston \(\#20\) is to be pulled out, remove handle assembly to access\.

Every seal is replaced here, so the plunger piston comes out too and the handle assembly is removed first\. The spring, spring cap and pivot pin numbers are read from the parts drawings on pp\. 10–11\.

### 6. 6 · Remove Cylinder Cap \#61

Remove cylinder cap \(\#61\) for Piston\.

### 7. 7 · Remove the Seals

Remove all O\-Rings &amp; Seals\.

From the p\. 11 section: \#63, \#62 and \#60 on the cylinder cap, \#58 in the ram cylinder, \#22 and \#23 in the plunger cylinder\. The \#24 copper seal under the plunger cylinder stays in place unless the cylinder is unscrewed\.

### 8. 8 · Fit the New Seals

Insert new O\-Ring or Seal one at a time making sure to replace with the same size that was removed\.

### 9. 9 · Re\-assemble

Re\-assemble\.

The manual gives no order; this follows the removal in reverse: cylinder cap, ram piston, plunger piston, handle and drain plug; the pump into the truck body, C\-clip \(\#78\), wheels and wheel shaft; then, upright, set screw \(\#102\)\.

### 10. 10 · Refill the Oil

Refill oil to correct level \(80% capacity or approximately 2 inches deep in reservoir\), and install oil fill plug\.

Do not overfill\. After filling and re\-installing plug, bleed the pump\. \(Lubrication, p\. 7\)

### 11. Bleed 1 · Pump, Then Lever Down

Pump handle quickly raising pallet truck to full extent\. While continuing pump action, pull lever to down position\.

### 12. Bleed 2 · Forks Fully Down

When forks reach total down position, valve is flushed\. Repeat if necessary\.

Never leave a loaded pallet truck unattended in the raised position\. Always lower load to the floor\.
