Find why a stored Honda GP160 pull-start engine will not start, one check at a time
Turn the fuel valve lever under the tank to ON. Pull the hose off the carb end for a second: petrol should drip from it. No drip? The valve or its filter screen is blocked.
Fresh petrol in the tank does not clean the carb. Fuel left in the carb for a year turns to gum.
Hold a jar under the float bowl (the cup under the carburettor) and loosen the drain bolt. Let the old fuel run out, then tighten the bolt.
Smells like varnish, or brown and sticky? Take the bowl off and spray the jet and passages with carb cleaner.
Pull the plug cap off and unscrew the plug with a plug spanner. Wet? Dry it. Black and sooty, or worn? Fit a new NGK BPR6ES. Set the electrode gap to 0.7–0.8 mm with a feeler gauge, then refit it.
Electrode gap: the space the spark jumps across at the plug tip.
Move the choke lever to CLOSED for a cold start. Choke: a flap that cuts the air so the engine gets a richer mix. Then set the engine switch to ON.
No fire after 3–4 pulls? Stop and check the plug again: a wet plug means the engine is flooded.
Unscrew the wing nut, lift the cover off and take out the foam element. Dirty? Wash it in warm soapy water, let it dry, then squeeze in a little clean engine oil.
Soaked in petrol? The carb is overfilling: the float valve is stuck, so clean the carb.
Pull the grip slowly until you feel resistance (compression), let it go back a little, then pull briskly all the way. Open the choke bit by bit once it runs.
No resistance at all could mean a valve or head gasket fault, which is unlikely after storage.