# Pro Dual Vertical Stand Setup

Set up two Infraredi Pro Max panels as a Pro Dual on the vertical stand, step by step

By Jordan Van Hemert

Topic: Home & DIY

[Open the interactive Jig](https://ask.jig.com/j/h6EjZ7ZE64N2)

## Transcript

### 1. Pro Dual on the Vertical Stand

A Pro Dual is two Pro Max red light panels joined into one tall light, 1\.8 metres from end to end\. Here are the two devices, the connector bracket with its eight hand screws, the cables, goggles, manuals and the stand, already built from its own manual\. Tap any part to see its name\.

Each Pro Max is 908 × 220 × 60 mm and weighs about 9 kg\.

### 2. 1 · Lay Both Devices Face\-Down

Place both devices face\-down, end to end along their length, on a soft, scratch\-free surface\. Make sure the screens face the same way, so the backs line up\.

Device 1 is the top one when the light stands up\.

### 3. 2 · Place the Bracket

Lay the bracket across the joint with its hooks pointing away from the devices\. Half of it covers Device 1 and half covers Device 2\. Line its holes up with the holes on each device\.

### 4. 3 · Fit the First Screw

Push a hand\-tightening screw through a corner hole of the bracket and turn it clockwise by hand until it is snug\. No tools are needed\.

### 5. 3 · Fit the Other Seven

Fit the other seven screws the same way, four down each side of the bracket\. Now the two devices are joined into one\.

### 6. 4 · Hook onto the Stand

Carefully lift the joined devices, stand them up with the lights facing out and lower the bracket hooks over the stand’s two crossbars\. The bracket should line up and sit snug on the stand\.

Together they weigh about 18 kg, so lift slowly and carefully\.

### 7. 5 · Connect the Patch Cord

Behind the light, push the female end of the power patch cord into Device 1 and the male end into Device 2\. This short cord lets one wall socket power both devices\.

### 8. 6 · Plug the Power Cord into Device 2

Push the female end of the power cord into the lower socket on Device 2\.

### 9. 6 · Plug into the Wall

Plug the other end of the power cord into a wall outlet\.

### 10. 6 · Switch Both Devices On

Turn on the power switches on both devices, Device 1 and Device 2\.

### 11. 7 · Pairing Cable, If Needed

The devices should connect to each other on their own and work as one light\. If they do not, connect the pairing cable from the USB\-C port on Device 1 to the USB\-C port on Device 2\.

USB\-C is the small, rounded port below the power sockets\.

### 12. 8 · Press Power

Press the power button on the back of each device\.

### 13. 9 · Group and Start

In the controls, open Settings, then Grouping, set every device to Group and press Confirm\. Now one control runs both lights as a single unit\. Press start session and enjoy your red light therapy\.

The guide suggests sitting 15 to 30 cm from the light\.