ExploreMy JigsMission
MakeMake a Jig

© JigSpace Inc. 2026

jig.comContact@JigSpace on X

Gullaberg Shoe Rack Assembly

publicRemix · Free
ABy Alex

Build a four-compartment shoe cabinet step by step, then fix it safely to the wall

Transcript

14 steps · 2 min read
  1. 1

    Step 1: Gullaberg Shoe Rack

    This cabinet is 105 cm wide but only 22 cm deep, with four tilt-out compartments for about eight pairs of shoes. Here are the sides, rails, divider, top, doors, plastic bins, knobs and fittings. You need a flat-blade and a cross-head screwdriver. Tap any part to see its name.

    Work on a soft rug, and build it with a second person.

  2. 2

    Step 2: 1 · Rails onto the Left Side

    Stand the left side panel up. Push the four rails onto its little pegs, two at the top and two at the bottom.

A helper holds the side steady while you fit the rails.
  • 3

    Step 3: 2 · Slide In the Divider

    Slide the centre divider in from the front, between the top and bottom rails. Its cross strip will separate the upper and lower compartments.

  • 4

    Step 4: 3 · Fit the Right Side

    Push the right side panel onto the other ends of the rails. Now the frame has four corners.

  • 5

    Step 5: 4 · Lock the First Cam

    A cam lock is a small metal disc that grips a bolt inside the joint. Drop it into the hole on top of the rail, then turn it half a turn clockwise with the flat-blade screwdriver.

  • 6

    Step 6: 4 · Lock the Other Three

    Lock the other three cam locks the same way. Each one pulls its joint tight.

  • 7

    Step 7: 5 · Put the Top On

    Lower the top straight down onto the frame. It hangs over a little at the front and sides.

  • 8

    Step 8: 6 · Hang the Coat Hook

    Fit the black coat hook to the outside of the left side, near the top. It is handy for a bag or a shoehorn.

  • 9

    Step 9: 7 · Fix It to the Wall

    This cabinet is tall and shallow, so it could tip forward. Drive a screw through the top back rail into the wall, turning clockwise.

    Use the right plug for your wall. Ask an adult to drill the holes.

  • 10

    Step 10: 7 · The Second Wall Screw

    Drive the second screw the same way. Now the cabinet cannot tip over, even if someone pulls a compartment hard.

  • 11

    Step 11: 8 · Bins onto the Doors

    Each compartment is a plastic bin with a door on its front. Lay the doors face down and press a bin onto the back of each one.

  • 12

    Step 12: 9 · Fit the Compartments

    Fit each compartment into an opening. The bins pivot near their bottom edge, so the door tips out at the top to show the shoes inside.

  • 13

    Step 13: 10 · Screw On the Knobs

    Turn a wooden knob onto each door, clockwise, until it is snug.

  • 14

    Step 14: Done

    Your shoe cabinet is ready. Put the heaviest shoes in the lower compartments, and never climb on the cabinet.