# Caroma Opal Cleanflush spare

Find the inlet valve, outlet valve and fixing spares inside a Caroma Opal Cleanflush cistern, with their Caroma part numbers, and see which part matches a symptom and where the water level is set\.

By Numa

Topic: Home &amp; DIY

[Open the interactive Jig](https://ask.jig.com/j/nYc4K7lpohVA)

## Transcript

### 1. Opal Cleanflush Suite

Caroma Opal Cleanflush Easy Height wall\-faced close coupled suite, 985400W, from Caroma's own 3D model: pan, cistern, push button and seat\. Tap any part to see its name\.

### 2. Lift the Cistern Lid

Tap the lid to lift it off\. Inside are the two serviceable assemblies: the UniFill back entry inlet valve on the right and the M5 Quietflow outlet valve under the push button\.

### 3. Exploded View

The cistern spares, laid out after Caroma's exploded spare\-parts sheet\. Tap any part to see its name and Caroma part number, exactly as printed\.

Source: Opal Cleanflush, Opal II &amp; Opal 2000 cistern spares, sheet 622306W, Revision 5, 30/04/2024\.

### 4. Which Part Do I Need?

Pick a symptom card to highlight the part to look at, with its part number\.

Concept mapping: Caroma's parts sheet and instructions do not link faults to parts\. Your service team would supply the real mapping\.

### 5. Lift Out the Valves

Tap the outlet valve to lift it out with its repair kit part \(405889\) and set it back\. The cistern instruction sheet does the same for the inlet valve: "Remove inlet valve to gain access to the right hand cistern fixing hole\." \(step 1\) "Refit the inlet valve into position\." \(step 6\)

Quotes: Opal II &amp; Opal CF CC cistern instruction sheet, Issue 4\. It gives no outlet valve procedure, torque or sealing advice; the outlet valve lift shows the parts only\.

### 6. Water Level Adjustment Point

Tap the float arm screw on the inlet valve\. "Adjust water level to the 4\.5 litre water level mark inside the cistern by simply turning the float arm screw in a clockwise or anti\-clockwise direction as detailed in Fig\. 3\."

Cistern instruction sheet, Issue 4, step 9\. Fig\. 3 draws the two turn arrows but does not name clockwise or anti\-clockwise; the turns shown follow its arrows\.

### 7. About This Concept

Concept built by JigSpace from Caroma's public documents\. Imagine it from your own CAD, with your part numbers, kept current by your team\.
