How a five-speed manual transmission trades engine speed for pulling force
Between a car’s engine and its wheels sits a box of spinning gears. By choosing which pair of gears carries the engine’s power, the driver decides whether the car pulls hard or cruises fast. Let’s look inside.
A five-speed gearbox with reverse, cut open like a museum exhibit. Drag to turn it.
An engine spins fast but pushes gently, while wheels pulling away need a slow, strong push. Gears make that trade: here a 13-tooth gear drives a 35-tooth gear, so the big one turns almost three times more slowly and pushes almost three times harder.
Follow the blue painted teeth. Speed times push stays the same: gears trade one for the other, they never add power.
The engine’s flywheel never stops while the engine runs. A strong spring squeezes the clutch disc against it, so the gearbox turns with the engine. Press the pedal and the disc lets go: the engine keeps running, but no power flows into the gears.
That short break in the power is what lets the driver change gear or stop without stalling.
Power enters on the input shaft, drops to the countershaft below, then climbs back up to the output shaft that turns the wheels. Every gear pair is always meshed, so in neutral the gears spin freely around the output shaft while the shaft itself, with its painted stripe, stays still.
The gears on the output shaft ride on needle bearings, so they can turn at a different speed from the shaft inside them.
To pick a gear, a fork slides a sleeve along the output shaft. First a brass ring rubs on a cone on the gear until the gear and the shaft spin at exactly the same speed. Only then can the sleeve’s dog teeth slide over and lock the gear to the shaft.
Before synchronisers, drivers matched speeds by ear with a “double declutch”, or the teeth would grind.
Choose a gear and follow the glow. Power always enters the same way, then climbs through the one pair you have locked. First uses a small gear driving a big one for a strong pull, fourth locks the input straight to the output, and fifth turns the output faster than the engine.
Ratios in this gearbox: 1st 3.77, 2nd 2.14, 3rd 1.40, 4th 1.00 and 5th 0.84 to 1, close to Toyota’s W56.
Now drive away. In each gear the engine revs up, the clutch dips, the lever moves and the next pair takes over at a lower engine speed. The output shaft keeps getting faster while the engine swings between the same comfortable speeds.
The numbers by the lever show engine and output shaft speeds in turns per minute.
Two meshed gears turn in opposite directions, so after two meshes the output turns the same way as the engine. Reverse slides a small idler gear in between the countershaft and the output shaft: one extra gear, and the output turns backwards.
The white arrows show which way each end turns. Reverse has no synchroniser, so stop the car first.
Take it apart: the case, the forks, the countershaft and every gear on the output shaft. A few dozen parts turning in oil let one engine pull a heavy car up a hill or cruise quietly on the motorway.
A gearbox like this weighs about 34 kg (75 lb) and is about 39 cm long.