ExploreMy JigsMission
MakeMake a Jig

© JigSpace Inc. 2026

jig.comContact@JigSpace on X

How Pencils Are Made

publicRemix · Free
NBy Numa

How a pencil is built from cedar slats, graphite cores and glue, then sliced into a dozen pencils at once and finished with paint, a ferrule and an eraser.

Transcript

7 steps · 2 min read
  1. 1

    Step 1: A pencil factory line

    Pencils are not drilled out of a stick of wood. They are built like a sandwich: two thin boards of wood with rods of graphite in between, sliced into a dozen pencils at once. Watch the line run, or tap a floating number to visit that station.

    Graphite is a soft, dark form of carbon. That is what leaves the mark on your paper.

  2. 2

    Step 2: Station 1: a cedar slat with grooves

    Each batch starts as a slat: a thin, flat board of incense-cedar, a soft wood that sharpens easily. A grooving machine has cut half-round channels along its whole length. This slat has twelve grooves, one for each pencil.

A slat is about 18 centimetres long, the length of a new pencil. Many factories cut six to nine grooves in one; this slat holds twelve.

  • 3

    Step 3: Station 2: lay in the graphite cores

    The cores are thin rods of graphite mixed with clay, baked hard in a kiln. A machine drops one into every groove. Tap the slat, or press Drop the cores.

    More clay makes a harder, paler pencil; more graphite makes a softer, darker one. Pencil lead contains no lead at all.

  • 4

    Step 4: Station 3: glue, then the sandwich

    Glue is spread on the slat, and a second grooved slat goes on top with its grooves lined up. Each core is now locked inside a round tunnel. Drag the top slat down onto the cores, or press Close the sandwich.

    The sandwich is clamped until the glue sets, so the two slats become one solid block.

  • 5

    Step 5: Station 4: slice a dozen at once

    Now the best part. Two spinning cutters, one above and one below, each have a row of V-shaped grooves the shape of half a pencil. As the sandwich passes between them, they carve all six sides of every pencil at once. Drag the sandwich into the cutters, or press Slice it.

    Each core ends up right in the middle of its pencil, exactly where the two grooves met. The leftover wood flies off as sawdust and shavings.

  • 6

    Step 6: Station 5: paint and a cap

    Each pencil gets several coats of glossy paint, classic yellow here. Then a metal band called a ferrule slides onto the end and is squeezed tight. A rubber eraser pushes into the ferrule and is held fast.

    A pencil usually gets between four and ten coats of paint.

  • 7

    Step 7: Station 6: packed, and round again

    The finished pencils hop into a box, the flaps fold shut and the box rolls away. A fresh slat is already starting down the line. Groove, fill, glue, slice: four simple moves make a dozen pencils at once.

    Next time you sharpen a pencil, look closely at the end. You may spot the faint line where two slats were glued together.