# Jongmeori Styler Guide

How to swap the four tools of a hair styler and use each one to make soft C\-curls, air\-wound curls and natural bends safely\.

By 세똥이

Topic: Home &amp; DIY

[Open the interactive Jig](https://ask.jig.com/j/v9lvhjuKn9mr)

## Transcript

### 1. One body, four tools

Meet the Jongmeori Styler: one slim handle that heats and blows air, and four tools that click onto its top\. A flat iron, a thin barrel, a thick barrel and a round brush each make a different kind of curl\.

The handle is 34 mm across and 200 mm long, about as long as a new pencil\.

### 2. Three controls

From the top: the gold release button, the temperature switch and the power switch\. Temperature runs from the bottom up: C for cool air, then L, M and H for low, medium and high heat\. Try each setting and watch the air slots\.

Keep hands, cloth and hair away from the air intake grooves near the bottom\.

### 3. Swap a tool

Switch OFF, unplug and let everything cool on a heat\-proof mat first\. Hold the release button and pull the tool straight up\. Line up the little key with its groove, push the new tool 20 mm down, let go and give it a gentle tug\.

If the tool wobbles or the button does not spring back, do not use it\.

### 4. Get the hair ready

Hair holds its shape with tiny links called hydrogen bonds\. Heat and water loosen them, and they lock again as hair cools and dries\. Hot plates need fully dry hair, while the air tools work best on hair that is mostly dry and just a little damp\.

Start with a small strand on a low setting to see how your hair reacts\.

### 5. Flat iron: a soft C\-curl

Take a thin strand, 1 to 2 cm wide, and start on L\. Clamp it gently halfway down and glide toward the ends without stopping\. Near the last 2 to 3 cm, roll your wrist a quarter turn, open the plates and let the curve cool\.

On the flat iron, C simply stops the heat\. The plates cool down slowly\.

### 6. Barrels: curls wound by air

Hold the barrel upright and bring the hair ends near its slots\. Air hugging the curved barrel pulls the strand round by itself, so you never wind it by hand\. Move up slowly, switch to C to cool the curl, then switch OFF and slide the barrel out downward\.

Air that clings to a curved surface is called the Coanda effect, after the inventor Henri Coanda\.

### 7. Round brush: a natural bend

Slip the brush under the strand and comb from the middle toward the ends with a light pull\. When 3 to 5 cm are left, roll the brush a quarter to half turn so the ends bend into a soft C\. Cool it on C, switch OFF and unroll the brush the opposite way\.

Never wind long hair round the brush many times\. If it tangles, switch off, cool and unwind gently\.

### 8. Cool, clean and store

When you finish, switch OFF, unplug and let the handle and tools cool on the mat\. Brush out loose hairs, wipe the outside with a barely damp cloth and never rinse the parts in water\. Store the tools side by side where small hands cannot reach\.

Curling or straightening with heat is temporary: the next wash or a humid day undoes it\.
