ExploreMy JigsMission
MakeMake a Jig

© JigSpace Inc. 2026

jig.comContact@JigSpace on X

Disconnecting the Jack – JD 6295M

publicRemix · Free
GBy greenlig

Lower the hitch jack and unhitch a towed implement from a John Deere 6M tractor, step by step

Transcript

7 steps · 1 min read
  1. 1

    Step 1: Disconnecting the Jack – JD 6295M

    Unhitch a land roller from the drawbar of a John Deere 6M-series tractor. Its hydraulic hitch jack, two hydraulic hoses, the hitch pin and a safety chain connect it to the tractor.

    Work on firm, level ground with nobody between the tractor and the roller.

  2. 2

    Step 2: 1 · Lower the Jack

    Move the jack lever to lower the jack until the foot pad sits flat on the ground. Keep lowering until the jack lifts the tongue and the hitch eye stops pressing on the drawbar.

    Never pull the hitch pin while the tongue is loaded: it can whip upwards.

  3. 3

    Step 3: 2 · Park and Shut Down

    Set the park brake and stop the engine. Take the key out, then turn the jack’s ball valve to CLOSED so the jack holds its height.

With the engine stopped, move the SCV lever back and forth to release the hose pressure.
  • 4

    Step 4: 3 · Disconnect the Couplers

    Pull the pressure (+) and return (−) couplers straight out of the SCV outlets. Hang them in the coupler holder on the tongue so they stay clean and off the ground.

    Wipe the couplers and fit their dust caps.

  • 5

    Step 5: 4 · Pull the Pin and Chain

    Take the R-clip out of the hitch pin and lift the pin out of the drawbar. Then unhook the safety chain from the tractor and lay it over the tongue.

  • 6

    Step 6: 5 · Drive Clear

    Check that nothing still connects the roller, then drive slowly forward. The drawbar slides out from under the hitch eye and the roller stays on its jack.

    Look behind you before you move off.

  • 7

    Step 7: Done

    The roller is parked on its jack with the valve closed. Put the hitch pin and R-clip back in the drawbar so they are not lost.