# Collapsible Wooden Market Stand

Build a strong, collapsible market stand from 23 wooden slats, with bolts and wing nuts that let it fold away

By Mahdi El hasra

Topic: Home &amp; DIY

[Open the interactive Jig](https://ask.jig.com/j/yCE5iBvhsCkJ)

## Transcript

### 1. A Market Stand from 23 Slats

Your 23 slats, each 120 cm long, become a stand 120 cm wide with a counter and a shelf\. Saw some of them shorter first, as the note lists\. Rungs are the cross bars on each side, rails are the long bars at the back, and cleats are short pieces under the counter and shelf that hold their slats together\. Tap any part to see its name\.

Cut: 2 front legs 85 cm, 4 rungs 57 cm, 2 side braces 67 cm, 1 back brace 115 cm, 4 shelf slats 116 cm; offcuts make the cleats\. Buy: 6 bolts with washers and wing nuts, about 80 wood screws, outdoor glue and paint\. Tools: saw, drill, tape measure, square and clamps\.

### 2. 1 · Build the Two Side Frames

Lay each corner post and front leg on the floor, 60 cm apart\. Glue and screw a rung across them at the bottom and one at the top, then screw the diagonal brace between the rungs\. Drill 3 mm pilot holes first so the thin slats do not split\.

The diagonal makes a triangle, and triangles cannot be pushed out of shape\. That is what stops the stand wobbling\.

### 3. 2 · Stand the Frames Up

Stand both side frames up, 120 cm apart, with the rungs facing inwards\. This is a job for two people: one holds the frames steady while the other fixes the back\.

### 4. 3 · Place the Back Rails

Hold the three back rails against the back of the corner posts: one low, one at counter height and one at the very top\. Clamp each end and drill an 8\.5 mm hole through the rail and the post\.

### 5. 4 · Bolt the Back Rails

Push a bolt with a washer \(a flat metal ring that spreads the squeeze\) through each hole from the back and screw a wing nut onto it from the inside\. Wing nuts tighten by hand, so the stand comes apart again without any tools\.

Bolts hold far better than screws alone in thin wood, and they let the stand fold flat for the car\.

### 6. 5 · Screw On the Back Brace

Screw the long back brace corner to corner across the low and middle rails\. Like the side braces, it stops the stand leaning left or right\.

### 7. 6 · Make the Shelf and Counter

Stand the cleats on edge on the floor and screw the slats across them, two screws per slat into each cleat, leaving a 6 mm gap between slats\. The four shorter slats make the shelf and the five long ones make the counter\.

### 8. 7 · Slide the Shelf In

Slide the shelf in from the front, between the front legs, so it rests on the two low rungs\. Its cleats sit just inside the rungs and hold the sides apart\.

### 9. 8 · Lower the Counter On

Lower the counter onto the top rungs with its front edge level with the front legs\. Its cleats lock the top of the frames square, so the whole stand turns stiff\.

Keep heavy goods on the low shelf: a low load makes the stand harder to tip\.

### 10. Ready for Market Day

Push on a corner: the stand should not rock\. To fold it, lift off the counter and shelf, undo the six wing nuts and you have flat pieces for the car\. For a 200 cm roof like the shop model, add two 2 m posts and a canvas cover\.

Seal the cut ends and paint everything before the first outdoor market\.
